[rv7charlie]

Has anyone done this conversion, & are there plans for it?

This isn't about the merits of each; the builder of my -4 installed the manual trim cable on the 3rd lever of a throttle quadrant, and the lever action is backward (forward causes nose up trim).

I've got an old MAC electric trim servo & it just seems easier to install it than a Rube Goldberg affair to reverse the lever's action on the cable.

Thanks,

Charlie

 

[vic syracuse]

Cahrlie, early on there were some ofus who mounted the trim servo back on the aft deck by the tail, and used a bowden cable from the servo to the trim tab. It seemed to work quite well. It got rid of a whloe lot of weight, too.

Vic