SeanB Well Known Member Jan 27, 2019 #1 Hello! I?m trying to find a torque setting for Lord Mounts. The manual seems to indicate tightening until you bottom out on the internal tubes. Then adjust to get the cotter pin installed. Sound correct? No torque value? Thanks!
Hello! I?m trying to find a torque setting for Lord Mounts. The manual seems to indicate tightening until you bottom out on the internal tubes. Then adjust to get the cotter pin installed. Sound correct? No torque value? Thanks!
SeanB Well Known Member Jan 27, 2019 #2 Answer Found it. Per Drawing 46A (for RV 7), tighten to bottom out then torque to AN7 values. Thanks.
Answer Found it. Per Drawing 46A (for RV 7), tighten to bottom out then torque to AN7 values. Thanks.