PittsCondor
Well Known Member
We are going to install the new Garmin GNX375 Nav/ADSB Transponder and a Garmin GTR200B in our RV7A. Currently we have on old King KLN35A GPS and ICOM 200 Com. The new eqiupment will fit into our current panel cut outs. My question is: Should try and use our current wiring or would it be better to buy the the new equipment with 4 foot harnesses already made? The new Com radio has built in Intercom so we will be removing the intercom system to.
The following is a complete list of what we plan to remove:
KLN35A GPS
ICom 200
Transponder
Intercom
Incoder? Maybe if better to buy the GAE 12 Encoder.
We also have an old 2 axis autopilot that it would be great if we could interface with new 375. It's a Navaid Devices autopilot
Looking to install at a later date: Dual G5's or 1 G5 and G3x, plus Garmin autopilot.
I'm not a wiring guy so this is not my area of expertise. Any help / advice will be greatly appreciated.
The following is a complete list of what we plan to remove:
KLN35A GPS
ICom 200
Transponder
Intercom
Incoder? Maybe if better to buy the GAE 12 Encoder.
We also have an old 2 axis autopilot that it would be great if we could interface with new 375. It's a Navaid Devices autopilot
Looking to install at a later date: Dual G5's or 1 G5 and G3x, plus Garmin autopilot.
I'm not a wiring guy so this is not my area of expertise. Any help / advice will be greatly appreciated.