Hello,
Down the wing go wires for:
1. Strobes
2. Nav
3. Heated pitot
4. AOA pitot
5. Auto pilot
6. Landing / Taxi Light
All of these would be shielded Mil spec wire.
If I have a connector for each of these at the wing to fuselage intersection do I run into possible noise or interference issues if I have all the connectors at about the same place? How is this usually done? Molex, Dsub, else? specially with the high power items?
I know this may be a silly question. But I cant seem to find a definitive answer.
Thanks for your help!
Down the wing go wires for:
1. Strobes
2. Nav
3. Heated pitot
4. AOA pitot
5. Auto pilot
6. Landing / Taxi Light
All of these would be shielded Mil spec wire.
If I have a connector for each of these at the wing to fuselage intersection do I run into possible noise or interference issues if I have all the connectors at about the same place? How is this usually done? Molex, Dsub, else? specially with the high power items?
I know this may be a silly question. But I cant seem to find a definitive answer.
Thanks for your help!
Last edited: