kbalch
Well Known Member
Just wondering if such a thing exists...
I'd like to find a die/set holder about 1" tall. Something with a male end that'll plug into the lower receiver of my C-frame dimpler and with a matching female end opposite.
The idea is to use it to back rivet a few 470-type rivets immediately adjacent to a bulkhead flange.
Any ideas?
I'd like to find a die/set holder about 1" tall. Something with a male end that'll plug into the lower receiver of my C-frame dimpler and with a matching female end opposite.
The idea is to use it to back rivet a few 470-type rivets immediately adjacent to a bulkhead flange.
Any ideas?