Brantel
Well Known Member
I am looking at purchasing one or two of the EZ-Burr tools.
I like the design of them better than the Cogsdill version. Seems less likely to jam up and make a mess.
The two part numbers I have picked out are:
for #30 holes - EZL0129-02
for #40 holes - EZL0098-02
extra blades - L1A-02
I don't see any way to specify rake angle on the blades. Anyone have any advice? Is the default fine for our use or do I need a zero rake blade if offered?
I like the design of them better than the Cogsdill version. Seems less likely to jam up and make a mess.
The two part numbers I have picked out are:
for #30 holes - EZL0129-02
for #40 holes - EZL0098-02
extra blades - L1A-02
I don't see any way to specify rake angle on the blades. Anyone have any advice? Is the default fine for our use or do I need a zero rake blade if offered?