S slngsht Well Known Member Mar 12, 2017 #1 Plans indicate should be .125 thickness, but my actual measurement on the angle is .132. Can anyone confirm?
Plans indicate should be .125 thickness, but my actual measurement on the angle is .132. Can anyone confirm?
D David Paule Well Known Member Mar 12, 2017 #2 I sometimes find angles that have dimensions like that. I don't think it's that uncommon. On my RV-3B project, I go ahead and use them. Dave
I sometimes find angles that have dimensions like that. I don't think it's that uncommon. On my RV-3B project, I go ahead and use them. Dave
rzbill Well Known Member Mar 13, 2017 #4 Lorentz contraction perhaps? Maybe the extrusion line was travelling at 32% of the speed of light that day it was made?
Lorentz contraction perhaps? Maybe the extrusion line was travelling at 32% of the speed of light that day it was made?
S slngsht Well Known Member Mar 13, 2017 #5 Robin8er said: Maybe its in metric inches... Click to expand... maybe they looked me up and decided "this one's gonna need the thicker ones" I guess I will call vans. I'm not that far in the instructions, but these do not fit in the slots in the aft bulkheads without modification.
Robin8er said: Maybe its in metric inches... Click to expand... maybe they looked me up and decided "this one's gonna need the thicker ones" I guess I will call vans. I'm not that far in the instructions, but these do not fit in the slots in the aft bulkheads without modification.
