Triumph1974
Well Known Member
Hello Everyone,
I am getting ready to install my EHT sensors, and wanted to find out where others have installed their sensors - especially those with an 0-360, Skyview sensors, and a standard crossover Vetterman's exhaust.
Seems like due to the bend at the #1 cylinder you need to be ~2 1/8" down to get past bend, and 2 1/8 will get you just above the "pin hooks" weld on the #3 cylinder.
If anyone that has this set up and can comment or post photo's of your EHT locations that would be most appreciated.
Thanks,
Paul
I am getting ready to install my EHT sensors, and wanted to find out where others have installed their sensors - especially those with an 0-360, Skyview sensors, and a standard crossover Vetterman's exhaust.
Seems like due to the bend at the #1 cylinder you need to be ~2 1/8" down to get past bend, and 2 1/8 will get you just above the "pin hooks" weld on the #3 cylinder.
If anyone that has this set up and can comment or post photo's of your EHT locations that would be most appreciated.
Thanks,
Paul