I'm doing my load analysis and I have a few loads I can't find as of yet. I would like to get this done so I can purchase my materials and start wiring the front end of the bird.
I need the amp loading of the following items (14 VDC of course):
E-MAG
P-MAG
Van's flap motor
GRT EIS-4000
TruTrak ADI
Ray Alan trim servos under load
I'm rolling my own electrical system and am curious as to what most folks do. Did/will you "roll your own" or "smoke" Van's prepackaged brand? If you rolled your own, did you use one of the Nuckols Z diagrams?
Jekyll
I need the amp loading of the following items (14 VDC of course):
E-MAG
P-MAG
Van's flap motor
GRT EIS-4000
TruTrak ADI
Ray Alan trim servos under load
I'm rolling my own electrical system and am curious as to what most folks do. Did/will you "roll your own" or "smoke" Van's prepackaged brand? If you rolled your own, did you use one of the Nuckols Z diagrams?
Jekyll
Last edited: