LeonardWestermeyer
Member
I have been noticing a definite fuel odor in the cockpit of my 7A. Also noticed a blue stain where the vent line exits the cabin for the wing.
Thought it might be the flare compression nut loose, but tightening it did no good. About to replace the entire line, but decided to remove the AN833-4D pass-through elbow and to my amazement found this:
The hole was big enough to see it looking through the interior of the fitting!
Has anyone else had this happen to them?
It would be good to check your fittings for defects before installation!
Thought it might be the flare compression nut loose, but tightening it did no good. About to replace the entire line, but decided to remove the AN833-4D pass-through elbow and to my amazement found this:
The hole was big enough to see it looking through the interior of the fitting!
Has anyone else had this happen to them?
It would be good to check your fittings for defects before installation!
Last edited: