Hello all,
This is my first post, been reading this site for months though.
May I suggest you get someone to look over your rivets before going too much farther.
Couple of these are not looking too good, not sure if this is a camera induce issue or not.
The goal here is to make sure the skin doesn't pull on the part underneath and develop a stress point. You want it to go out a bit and then start the curve. It took me more than a few attempts to get it just right.
What are you using to do the "roll"?
I think they look much better in person. They do fit the gauge perfectly. I do plan on having an experienced builder look at it. If it's not acceptable, I won't be the first to build another rudder.
Thanks for all the input.