Jim P
Well Known Member
I'll put this under tools for lack of a better place but this was an idea our local EAA Chapter was interested in so I figured I'd post here:
In short, to organize my hardware (this is beyond the unbag or keep in bags debate), I use several plastic trays, the ones with about 20 smaller sections and a hinged cover, and have one tray each for AN3, AN4s, AN5s, Nuts, Washers, Screws, AN Fittings, Rivets, Gromets, etc. In order to label these, I created a bunch of Word Documents formatted to the Avery 8167 labels (Return Address label). If it helps anyone, I have the link here: http://www.adap.com/rv7/ideas.htm
If you get a password request, just hit <cancel> and it will download.
Jim
In short, to organize my hardware (this is beyond the unbag or keep in bags debate), I use several plastic trays, the ones with about 20 smaller sections and a hinged cover, and have one tray each for AN3, AN4s, AN5s, Nuts, Washers, Screws, AN Fittings, Rivets, Gromets, etc. In order to label these, I created a bunch of Word Documents formatted to the Avery 8167 labels (Return Address label). If it helps anyone, I have the link here: http://www.adap.com/rv7/ideas.htm
If you get a password request, just hit <cancel> and it will download.
Jim