mototopo Well Known Member Oct 12, 2010 #1 Quick question before proceeding, I need a clear answer to my doubt: looking at drawing 18, I understand I have to trim both ends of F-786 A/B/C J-stiffeners the same way. Is this correct?
Quick question before proceeding, I need a clear answer to my doubt: looking at drawing 18, I understand I have to trim both ends of F-786 A/B/C J-stiffeners the same way. Is this correct?
mototopo Well Known Member Oct 12, 2010 #2 Hi Arnie, thank you very much. The reason of my doubt was exactly that I found more logical to leave the aft end of the two upper stiffeners plain and flush with the bulkhead web but there is no mention of it in the plans. Thank you again!!
Hi Arnie, thank you very much. The reason of my doubt was exactly that I found more logical to leave the aft end of the two upper stiffeners plain and flush with the bulkhead web but there is no mention of it in the plans. Thank you again!!