alpinelakespilot2000
Well Known Member
Finally got my wing sweep to 0 degrees, my incidence (measured with the block) to 0.0 degrees, and am preparing to drill the rear spars. I've measured about the best I can 5/8" around all pieces. What I'm left with is what you see below inside the center box. It's about 1/8" wide by 1/4" tall. If I drill anywhere within this box I should have adequate edge distance all around.
Is this typical of how much leeway others have had in drilling the rear spar? Van's doesn't leave much extra for error, that's for sure! Just looking for confirmation before I do the deed! Thanks.
Is this typical of how much leeway others have had in drilling the rear spar? Van's doesn't leave much extra for error, that's for sure! Just looking for confirmation before I do the deed! Thanks.
Last edited: