dhall_polo
Well Known Member
Quick start, anyone?
Looking for a compiled list of values for programming the limits on EFIS gauges for parallel IO-360? (Mine happens to be IO-360-B1B, CS prop) I have read the engine manual, just figure this is something that's been done 1000 times by now.
[min, low red, low yellow, high yellow, high red, max]
for each gauge
[map, rpm, oil psi, fuel psi, fuel flow, oil temp, volt, bus, cht, egt]
Looking for a compiled list of values for programming the limits on EFIS gauges for parallel IO-360? (Mine happens to be IO-360-B1B, CS prop) I have read the engine manual, just figure this is something that's been done 1000 times by now.
[min, low red, low yellow, high yellow, high red, max]
for each gauge
[map, rpm, oil psi, fuel psi, fuel flow, oil temp, volt, bus, cht, egt]