I was cabling up my servo and found the control reversed. Full forward closes butterfly. Full aft throttle opens up. This is with the throttle on right as per the VANs diagram.
I bought a rebuilt IO0320-D1A to avoid as many interop issues as possible but I guess the philosophy doesn't always work. In this case the builder sent me a rebuilt RSA-5AD1 2524242-9
which appears to be for and IO-320 C & F. The application chart it's supposed to be 2524307 for the IO-320-D1A.
Is it best to send this back to exchange for the correct variant or is this easily adapted.
I'd also appreciate some setup help. I noticed cable travel is beyond 2-1/8". But it also appears the set screws are completely backed off. Set up correctly should I expect the full travel of the throttle cable to be the full range of the servo?
Thanks.
Michael B.
I bought a rebuilt IO0320-D1A to avoid as many interop issues as possible but I guess the philosophy doesn't always work. In this case the builder sent me a rebuilt RSA-5AD1 2524242-9
which appears to be for and IO-320 C & F. The application chart it's supposed to be 2524307 for the IO-320-D1A.
Is it best to send this back to exchange for the correct variant or is this easily adapted.
I'd also appreciate some setup help. I noticed cable travel is beyond 2-1/8". But it also appears the set screws are completely backed off. Set up correctly should I expect the full travel of the throttle cable to be the full range of the servo?
Thanks.
Michael B.