Djgeib
Active Member
Hi all,
I am the proud owner of a new RV8 empennage kit SN83603. It arrived the first week of November and I've been having a great learning experience as I sift through the plans. Must admit I get a little apprehensive each time I have to make a cut or a bend. But so far I am proud of the little bit of work I have accomplished. Just finished with the bends and counter sinking in the HS810/814 and the dimples in the HS702's.
My question has to so with the notches the instructions say to put in HS00006 rib to fit around the HS810/814. Does anyone have a picture of how they did this. I'm a bit confused as to how much to take off.
Thanks
I am the proud owner of a new RV8 empennage kit SN83603. It arrived the first week of November and I've been having a great learning experience as I sift through the plans. Must admit I get a little apprehensive each time I have to make a cut or a bend. But so far I am proud of the little bit of work I have accomplished. Just finished with the bends and counter sinking in the HS810/814 and the dimples in the HS702's.
My question has to so with the notches the instructions say to put in HS00006 rib to fit around the HS810/814. Does anyone have a picture of how they did this. I'm a bit confused as to how much to take off.
Thanks