Soarandtow
Active Member
I have the front spare drilled and bolted.
Slide the 11/32 bit under the rear and clamping down makes the rear spare lower than the front by a few mm. I'm measuring at the most rear and most forward rib tooling holes is this the correct places to measure from?
I can make it even by removing a little clamp pressure.
Also the plans don't give a exact location to drill the rear spare holes, should they just be centered or have I missed the hole location in the plans.
Any help on this would be great. Don't won't to have the horz incident off
Slide the 11/32 bit under the rear and clamping down makes the rear spare lower than the front by a few mm. I'm measuring at the most rear and most forward rib tooling holes is this the correct places to measure from?
I can make it even by removing a little clamp pressure.
Also the plans don't give a exact location to drill the rear spare holes, should they just be centered or have I missed the hole location in the plans.
Any help on this would be great. Don't won't to have the horz incident off