LettersFromFlyoverCountry
Well Known Member
DWG 49, Section E-E, shows a 3/8 distance between the forwrd edge of C- 613 (the splice plate conneting 716 and 725), and the aft edge of C-725 (the ball stud forward mount).
This presents a bit of a problem for me because the little wedge I made that fits under the 716 frame and the splice plate, didn't need to be inserted as far on my construct as in the plans, so it's sticking out beyond the splice plate about 7/16.," or 1/8" beyond the callout.
Is this going to cause a problem as long as I maintain the 9 11/16 critical dimension between the center of the hole in the ball stud forward mount and the center of the hole in C-728 (the ball stud aft mount)?
If this causes no problem, I presume I would want to also change the position of the mount on the opposite side, too.
Thanks
This presents a bit of a problem for me because the little wedge I made that fits under the 716 frame and the splice plate, didn't need to be inserted as far on my construct as in the plans, so it's sticking out beyond the splice plate about 7/16.," or 1/8" beyond the callout.
Is this going to cause a problem as long as I maintain the 9 11/16 critical dimension between the center of the hole in the ball stud forward mount and the center of the hole in C-728 (the ball stud aft mount)?
If this causes no problem, I presume I would want to also change the position of the mount on the opposite side, too.
Thanks