I'm struggling to get this Infinity Grip closed up all the way. I'm 100% sure no wires are pinched. I reduced the bundle size because I removed 2 of the buttons I wasn't using. I also ran all of the wires out of the trigger hole so they were no factor, and same issue. I can get it to close all the way at the bottom, so it must be too fat at the top of the stick? Grip closes up just fine with no stick in there.
All powdercoat/primer has been removed from the stick.
RV8 stick.
Keep reducing the OD of the stick at the tip, or start cutting away at the inside of the grip?
**EDIT: In the photos it looks like there might be something stuck in there about 2/3 of the way up the stick. That's actually just light shining back through the open trigger "window" as the trigger is not installed in these photos. I am 1000% sure no wires are pinched.
All powdercoat/primer has been removed from the stick.
RV8 stick.
Keep reducing the OD of the stick at the tip, or start cutting away at the inside of the grip?
**EDIT: In the photos it looks like there might be something stuck in there about 2/3 of the way up the stick. That's actually just light shining back through the open trigger "window" as the trigger is not installed in these photos. I am 1000% sure no wires are pinched.
Attachments
Last edited: