OK, OK, I get it. Sometimes we need to be humbled.
I'm trying to finish the wings, and I need to cut the Aileron push rods (the small rod about 2 ft long)
The plans keep saying to see DW9. So I look at drawing 9 and sure enough, there they are!
BUT NOWHERE do they say how long they need to be. Do I guess and keep fitting unit correct?
*OR*
Go to Van's Airforce and find out.
Also, I'm assuming you do not need to cut the big push rods at all. These big babies go from fuse to bellcrank.
Hey! I got two non leaking tanks, so I figure I'm ahead!
Dkb
I'm trying to finish the wings, and I need to cut the Aileron push rods (the small rod about 2 ft long)
The plans keep saying to see DW9. So I look at drawing 9 and sure enough, there they are!
BUT NOWHERE do they say how long they need to be. Do I guess and keep fitting unit correct?
*OR*
Go to Van's Airforce and find out.
Also, I'm assuming you do not need to cut the big push rods at all. These big babies go from fuse to bellcrank.
Hey! I got two non leaking tanks, so I figure I'm ahead!
Dkb