Not liking laser cut parts, even with proper prep, including extra reaming, single flute deburr, and good dies, still getting some slight cracking that I have to file out.
Just needed to rant, but I did send support a message about this, because I think there are going to be a lot of cracks in the next few years.
These are after an hour of filing and pad work, start of cracks all on the same position. I should have taken shots with the original, after each prep step, but didn't.
![IMG_4931.jpg IMG_4931.jpg](https://vansairforce.net/data/attachments/22/22715-b9d25adf76befbf1b86b3cd930054464.jpg)
![IMG_4932.jpg IMG_4932.jpg](https://vansairforce.net/data/attachments/22/22716-bfa14782b7de8e0436ef14dd7fc6bb81.jpg)
![IMG_4933.jpg IMG_4933.jpg](https://vansairforce.net/data/attachments/22/22717-bb950b02ece0fd0d18aebf373e5a42c0.jpg)
![IMG_4934.jpg IMG_4934.jpg](https://vansairforce.net/data/attachments/22/22718-5220d3b6b011a11f9cb14ba74555338f.jpg)
Just needed to rant, but I did send support a message about this, because I think there are going to be a lot of cracks in the next few years.
These are after an hour of filing and pad work, start of cracks all on the same position. I should have taken shots with the original, after each prep step, but didn't.
![IMG_4931.jpg IMG_4931.jpg](https://vansairforce.net/data/attachments/22/22715-b9d25adf76befbf1b86b3cd930054464.jpg)
![IMG_4932.jpg IMG_4932.jpg](https://vansairforce.net/data/attachments/22/22716-bfa14782b7de8e0436ef14dd7fc6bb81.jpg)
![IMG_4933.jpg IMG_4933.jpg](https://vansairforce.net/data/attachments/22/22717-bb950b02ece0fd0d18aebf373e5a42c0.jpg)
![IMG_4934.jpg IMG_4934.jpg](https://vansairforce.net/data/attachments/22/22718-5220d3b6b011a11f9cb14ba74555338f.jpg)
Last edited: