s10sakota
Well Known Member
Seriously, I am. Look at this ****. These are the F-633 pieces that hold the control sticks. I was to measure 3/8" down and 3/4" in. I carefully measured, center punched, used three increasing larger drill bits to drill the final hole size of 3/16", and then once complete, I put a bolt in them to see how perfect they were!
Here's the results...
Seriously what the hell?? Do I suck that bad? I guess somewhere between trying to measure accurately, marking with a fine sharpy, and then center punching, I'm a full1/32" off.
I'm guessing this won't matter over the roughly foot-and-a-half that they span, but I HATE when my work comes out like this.
I just don't know what to do differently when I measure, mark, and punch to be more accurate.
Here's the results...
Seriously what the hell?? Do I suck that bad? I guess somewhere between trying to measure accurately, marking with a fine sharpy, and then center punching, I'm a full1/32" off.
I'm guessing this won't matter over the roughly foot-and-a-half that they span, but I HATE when my work comes out like this.
I just don't know what to do differently when I measure, mark, and punch to be more accurate.
Last edited: