aarvig
Well Known Member
I am building my THIRD flappin set of these HS908 brackets. First set I screwed up cutting to close with the band saw. Second set I drilled the nine holes only to discover my edge distance was off by a bit too much. The third set everything is perfect except the center upper alignment hole I drilled has about 1/64th of an inch difference in height relative to the other center alignment hole on the other HS908. No matter how accurate I am with my measurements when I centerpunch the hole or when I drill I am off by a very small margin. My fear is that my horizontal stabilizer will not be sitting square on the fuselage.
My questions are as follows:
1.) Am I being to picky?
2.) Is there a way to drill the center upper alignment hole so that the two alignment holes end up in perfect alignment?
My questions are as follows:
1.) Am I being to picky?
2.) Is there a way to drill the center upper alignment hole so that the two alignment holes end up in perfect alignment?