[bradw3]

After drilling HS-405 to 702 to 710 I found I had an edge distance issue on the reinforcement angle HS-710. I dont know how to deal with this as the edge distance on 405 is right at a quarter inch so that hole couldn't be moved up any further. I have 3/16" from center of hole to edge on HS-710. Any suggestions on what I should do? Thanks.

 

[alpinelakespilot2000]

Brad-
I don't have my plans available to check what parts these are. Can you post a pic?

 

[chevy]

Here is a good link

Hope this helps.

http://www.vansairforce.com/community/showthread.php?t=74336&highlight=Edge+distance