I just finished rounding and beveling the edge of the HS-609PP that fits against the rear spar. I am curious if I beveled it too much where it could have removed too much material. I still have 1/4in edge distance to the last hole, but the thickness at the edge is only 0.14in vs. 0.1875 in thickness. I did not want to bevel it too little, but it was difficult to judge what was sufficient.
I would appreciate any feedback
Thanks!
https://eaabuilderslog.org/?blproject&proj=7YL1dRvO9&add
I would appreciate any feedback
Thanks!
https://eaabuilderslog.org/?blproject&proj=7YL1dRvO9&add