DunkirkRV7
I'm New Here
Hello all, I tried searching but had no luck. So if I missed a post that covers this, I apologize.
I have a seen a lot of comments on how the steps for the front spar of the HS are a little lacking.
Well, needless to say I got my second set of Front HS Spar parts because of the whole edge distance issue.
This time around, before I get to that part of the build, I wanted to ask. I'm wondering if there is a really good method or best practice to marking out the bend lines for HS-702,710, and 714. Does anyone have a good builder log or link to images/videos to how they or someone went about measuring the bend lines accurately on these parts, and drilling the relief holes?
Last time the way I did it they fit tight and perfect, BUT, I feel like i got very lucky (which upset me that i messed up edge distance on the holes). Just wondering if someone has a good documented video or image set to help me out.
TIA for any assistance!
David
I have a seen a lot of comments on how the steps for the front spar of the HS are a little lacking.
Well, needless to say I got my second set of Front HS Spar parts because of the whole edge distance issue.
This time around, before I get to that part of the build, I wanted to ask. I'm wondering if there is a really good method or best practice to marking out the bend lines for HS-702,710, and 714. Does anyone have a good builder log or link to images/videos to how they or someone went about measuring the bend lines accurately on these parts, and drilling the relief holes?
Last time the way I did it they fit tight and perfect, BUT, I feel like i got very lucky (which upset me that i messed up edge distance on the holes). Just wondering if someone has a good documented video or image set to help me out.
TIA for any assistance!
David