AJ85WA
Well Known Member
Hi Guys
Obviously I will double check with Vans but just wanted to get some input from guys on here.
The issue is that I have already completed all my wiring going to the wings from the panel. It goes down the centre under the tunnel cover and then through the spar web where the two spars connect and under the seats to the wings.
But when I checked out my wings (already closed and wired) the wires run in front of the spar and i am looking for a way to get it behind to meet up with the other wires from the panel.
Would it be ok to drill a small hole in either of the arrow locations? Just your opinions.
Obviously I will double check with Vans but just wanted to get some input from guys on here.
The issue is that I have already completed all my wiring going to the wings from the panel. It goes down the centre under the tunnel cover and then through the spar web where the two spars connect and under the seats to the wings.
But when I checked out my wings (already closed and wired) the wires run in front of the spar and i am looking for a way to get it behind to meet up with the other wires from the panel.
Would it be ok to drill a small hole in either of the arrow locations? Just your opinions.
![RV6SPAR_zps1dd982ff.jpg](/community/proxy.php?image=http%3A%2F%2Fi1106.photobucket.com%2Falbums%2Fh379%2FAj85wa%2FRV6SPAR_zps1dd982ff.jpg&hash=391f06a99989c1cdf4d2d95a36859819)