Kahuna
Moderatoring
I have the need to remove some/all crank flange prop bolt bushings on my lyco for a prop clocking project. I toyed with this some time ago with a bolt and some oversized nuts and washers to pry it out but was not able to get one out. I need to remove 6 of them.
The gismo I made should have worked but didnt.
There is supposed to be a tool for this but I have never seen one, and cant find one on the web.
So 2 questions.
1. If you have experience removing these please lend me your technique. Big hammers? Heat? Right tool?
2. If you have one of these tools to lend out I would appreciate that too, or point me to where I can find one.
Thanks
The gismo I made should have worked but didnt.
There is supposed to be a tool for this but I have never seen one, and cant find one on the web.
So 2 questions.
1. If you have experience removing these please lend me your technique. Big hammers? Heat? Right tool?
2. If you have one of these tools to lend out I would appreciate that too, or point me to where I can find one.
Thanks