[scottw]

Gents, about to mount the engine 0-320 dyno, presently installing governor and 45 degree oil pressure fitting, my questions at this point are, what is the best orientation of the governor cable bracket to facilitate routing/hookup? and which port/what angle should the pressure fitting be installed in to interfere the least? thanks for the help!

 

[KleensRV6]

Scott,

If this pressure fitting is located by the upper right engine mount it should be clocked in the 7 or 8 oclock position as you look at the fitting. There is a tool (always is) for mounting the fitting that is nothing more than a tube. The tube screws on to the end of the fitting to get a firm fit. If not installed in the correct position it can interfere with the engine mount, and if not tight enough a weeping leak will exist. Just one of those things you pick up along the way.