GNX 375 connections to GDU-460
Rookie question here, hope someone with patience can help.
A bit confused as to how to wire the RS-232 connections from GNX 375 to
GDU-460.
This will be a single screen system. Referring to the GNX-375 installation instructions, the interconnect diagram on page 109, Rev 7, the RS-232 wiring is shown connected to:
GDU 4XX/37X
(PFD or MFD)
using two sets of RS-232 signals (in/out/ground) from the GNX 375
and
GDU 4XX
(PFD1 only)
using one set RS-232 signals from the GNX 375
So my question is when using a single display, which connections do I use to get the most out of the GDU-460 or am I simply confused by terminology and should connect all?
Thanks
Rookie question here, hope someone with patience can help.
A bit confused as to how to wire the RS-232 connections from GNX 375 to
GDU-460.
This will be a single screen system. Referring to the GNX-375 installation instructions, the interconnect diagram on page 109, Rev 7, the RS-232 wiring is shown connected to:
GDU 4XX/37X
(PFD or MFD)
using two sets of RS-232 signals (in/out/ground) from the GNX 375
and
GDU 4XX
(PFD1 only)
using one set RS-232 signals from the GNX 375
So my question is when using a single display, which connections do I use to get the most out of the GDU-460 or am I simply confused by terminology and should connect all?
Thanks
Last edited: