Hi.
I just bought a new GTN 650 and a new G5. I also bought a used Tru TraK Sorcerer and roll and pitch servos and auto-trim module formerly installed in a RV-10.
All of them are to be installed in my RV-7, except the servos and the auto trim module. The GTN will be connected to a GA35 antenna and to the G5 HSI fonction.
The Sorcerer is a substitute for an ADI Pilot II autopilot formerly installed in my RV-7. It will use the roll and pitch servos already installed in the plane
Someone can provide me with the wiring diagram to connect and interface those equipment in a way that the GTN will drive the Sorcerer in GPS steering mode?
Thanks for your time. Alain
I just bought a new GTN 650 and a new G5. I also bought a used Tru TraK Sorcerer and roll and pitch servos and auto-trim module formerly installed in a RV-10.
All of them are to be installed in my RV-7, except the servos and the auto trim module. The GTN will be connected to a GA35 antenna and to the G5 HSI fonction.
The Sorcerer is a substitute for an ADI Pilot II autopilot formerly installed in my RV-7. It will use the roll and pitch servos already installed in the plane
Someone can provide me with the wiring diagram to connect and interface those equipment in a way that the GTN will drive the Sorcerer in GPS steering mode?
Thanks for your time. Alain