Did you roll your own landing gear intersection fairings or purchase? Inquiring minds want to know. I have actually started the journey of rolling my own - so far so good.
I had Sam James wheel pants so I was going to have to lay the lower set by hand so I went ahead and did the top at the same time. No sweat... Just a lot of cursing and sanding.
With the old engine I made the lower fairings but bought the uppers. The uppers never did fit well because they were for the -7. (No one makes fairings for the -9.)
With the new cowl I will make the uppers. (This week, if all goes well.)