[8MikeXray]

I am laying out my RV-8 panel and would like my GDU375 installed with the screen located on the centerline of the panel.

I need to find out where the center of the GDU375 screen is in relation to the two lower mounting holes.

I would like my G3X panel cutout slightly offset to the right so I could position the screen on center. Could anyone please take a ruler and position it on center of the left lower mounting hole across the bottom of the softkeys to the right lower mounting hole and send me a picture? This will give me the much needed dimensions to locate my panel cutout. I can not find these needed dimensions in the install manual.

Thank You Very Much,

Mike

 

[Longez]

Mike,

The center of the GDU 375 screen is 2.28 in. to the right of the lower left mounting hole and 3.10 in. to the left of the lower right mounting hole. I actually measured to the center of the middle softkey which is centered on the glass.

 

[Longez]

I added the display glass centerline dimensions to this drawing: