For various reasons (read: i messed up) I managed to drill the inspection cover slightly off center from the large hole. These pictures should explain what i mean (I realize it is cleco'd together backwards):
The tooling hole is now no where near covered by the backing plate. I feel like this is all a pretty minor issue all things said and done, but i'm not sure.
Should I build-on or does this need some kind of attention?
The tooling hole is now no where near covered by the backing plate. I feel like this is all a pretty minor issue all things said and done, but i'm not sure.
Should I build-on or does this need some kind of attention?