UnPossible
Well Known Member
Hey - I am trying to install the GPS antennea for Garmin's G3X system. Before Garmin's big price reduction, I had been planning on using Dynon's Skyview and had drilled the holes in the top turtle deck for their GPS antennea. (Note - canopy will be a tip-up)
As you can see in the picture below, the top two holes for both antenneas match, however, the Garmin antennea is a bit longer. Unfortunately, one of the holes required for the Garmin will remove about 1/2 of a rivet. Would it be acceptable for me to drill out the rivet, drill the new hole where indicated, install a nut plate, then fill what's left of the rivet hole with epoxy and flox?
Is there a better solution, or do I need to move this forward a bit and drill all new holes?
Thanks for any suggestions,
Jason
As you can see in the picture below, the top two holes for both antenneas match, however, the Garmin antennea is a bit longer. Unfortunately, one of the holes required for the Garmin will remove about 1/2 of a rivet. Would it be acceptable for me to drill out the rivet, drill the new hole where indicated, install a nut plate, then fill what's left of the rivet hole with epoxy and flox?
Is there a better solution, or do I need to move this forward a bit and drill all new holes?
Thanks for any suggestions,
Jason