Hi all,
Working on my tip-up RV7A. When i was working on the f-702 skin and f-771, i had an acceptable 0.032 gap as suggested in instructions. However, after i continued working on the canopy frame, and am getting ready to start work on canopy itself, i find the gap has increased to 3/32 on the top portion. No idead how. On the sides it is less than 1/32. I tried to close the gap but it is not working. A lot has been drilled and clecoed/riveted to allow any movement in skin. Should i just leave it alone? if for aesthetic reasons i can live with that but what i do not know if this will affect canopy install or not. Any suggestions?
Thank you
Working on my tip-up RV7A. When i was working on the f-702 skin and f-771, i had an acceptable 0.032 gap as suggested in instructions. However, after i continued working on the canopy frame, and am getting ready to start work on canopy itself, i find the gap has increased to 3/32 on the top portion. No idead how. On the sides it is less than 1/32. I tried to close the gap but it is not working. A lot has been drilled and clecoed/riveted to allow any movement in skin. Should i just leave it alone? if for aesthetic reasons i can live with that but what i do not know if this will affect canopy install or not. Any suggestions?
Thank you
![iw7iaa.jpg](/community/proxy.php?image=http%3A%2F%2Fi57.tinypic.com%2Fiw7iaa.jpg&hash=a32cbee3eb0f1fefc58f05ebb68dc817)