Wondering if anyone else has had this experience. The display's been working flawlessly since I bought the plane in 2019. Garmin's been quick to respond, asking for some info that will have to wait a couple days till I get to the hangar. Here's the scenario...
This is in an RV-12iS (E-LSA).
This is in an RV-12iS (E-LSA).
- On 1/28/31 I replaced my GSA 28 servos per Garmin SB 23038 Rev A dtd 5/4/23. Also complied with Vans SL-00055. All went well.
- Before flight 1/31/24, I updated the G3X firmware from V9.14 to V9.31. On reboot, I went into Config mode and watched the LRUs update, including the new servos. When that completed, I shut down.
- During flight afterwards, I engaged Smart Glide (for the first time), and all seemed well at first. I disengaged the Autopilot. When I pressed the Smart annunciation at the bottom of the display to bring up the Smart Glide screen, the display went black for a few seconds and rebooted.
- Later in the flight, I had the autopilot on for a while in HDG, NAV and LVL modes...all functioned as expected. Turned off the autopilot. I re-engaged Smart Glide, subsequently disengaged the autopilot, and touched the annunciation again. This time the expected screen appeared and I cancelled Smart Glide.