Phantom30
Well Known Member
Has to be a weekend....(finally got my GPS 20A Friday afternoon). Mean while @ the hanger today, hardware installed no problems; however, the wiring harness supplied leaves me with several questions.
1-on page 61-05 rev#0..it states to run red wire (tq3058) to es batt tcw 3ah 15 pin d-sub position 12, and run red wire (tq3007) to be spliced onto wht/red wire f1117 that comes out of egis wh-00101 50 pin d-sub...."there is only 1 red wire which runs from GPS d-sub to both ads-b and nav/com d-subs".
Note: on the plans red wire (tq3058) is shown with pin installed that goes
into battery d-sub.
2-on page 61-06 rev#0..(with a note that if purchased you Garmin avionics kit after 02/26/2016 skip the following steps)
Install wiring harness wh-00130 (tq3057) wht (looks to be shielded) into pin 2 of the xpndr d-sub with the other end into pin 24 of the xpndr 62 pin d-sub, and run green wire (tq3058) which connects to shield of (tq3057) to pin 50 of xpndr 62 pin d-sub.
Note: no such wiring harness (wh-00130) was in upgrade kit????
For you guys who have installed GPS 20A upgrade.....help!!!!
1-on page 61-05 rev#0..it states to run red wire (tq3058) to es batt tcw 3ah 15 pin d-sub position 12, and run red wire (tq3007) to be spliced onto wht/red wire f1117 that comes out of egis wh-00101 50 pin d-sub...."there is only 1 red wire which runs from GPS d-sub to both ads-b and nav/com d-subs".
Note: on the plans red wire (tq3058) is shown with pin installed that goes
into battery d-sub.
2-on page 61-06 rev#0..(with a note that if purchased you Garmin avionics kit after 02/26/2016 skip the following steps)
Install wiring harness wh-00130 (tq3057) wht (looks to be shielded) into pin 2 of the xpndr d-sub with the other end into pin 24 of the xpndr 62 pin d-sub, and run green wire (tq3058) which connects to shield of (tq3057) to pin 50 of xpndr 62 pin d-sub.
Note: no such wiring harness (wh-00130) was in upgrade kit????
For you guys who have installed GPS 20A upgrade.....help!!!!