mototopo
Well Known Member
I'm assembling the firewall and I'd like to prepare it for the installation of all the major accessories before final assembly.. I think it's easier to do it now instead then once the FW is installed on the fuse.
For this reason I'm going to order from Van's the following items:
1. PC680 battery installation tray/kit
2. Gascolator doubler (I'll install an Andair gascolator later but I think installing the doubler now is a good idea)
3. Master relay and starter contactor
What else do I need?
I'm planning the engine will be a IO-360-M1B or -A1B6 (CS)
Do the holes for cables, fuel lines, wires etc. as shown on DWG 19 fit well or is better to drill the holes later?
Last question: which kind of metal grommets works best? On Van's accessory catalog there are 3 models: one hole, aluminium and steel bulkead fittings. Any suggestion?
Thanks
For this reason I'm going to order from Van's the following items:
1. PC680 battery installation tray/kit
2. Gascolator doubler (I'll install an Andair gascolator later but I think installing the doubler now is a good idea)
3. Master relay and starter contactor
What else do I need?
I'm planning the engine will be a IO-360-M1B or -A1B6 (CS)
Do the holes for cables, fuel lines, wires etc. as shown on DWG 19 fit well or is better to drill the holes later?
Last question: which kind of metal grommets works best? On Van's accessory catalog there are 3 models: one hole, aluminium and steel bulkead fittings. Any suggestion?
Thanks