WingsOnWheels
Well Known Member
I'm just about done building the fuselage jig. I was wondering what is the best way to ensure that the builhead supports are at an even height (the 2X4s that sit on edge - not attached in the picture, you can see them on the workbench)? Do you lay the longerons across them (before bending) and look for gaps?
Ignore the extra 2x6s in the picture, those are the first set I bought that I decided were not straight enough.
Since my garage floor isn't even close to flat or level, I added adjuster screws to the bottom of the legs. Has anyone else done this? How did it work out for you?
Just for fun: I have been playing around with panel layouts - a bit premature...
So far I like this one.
Ignore the extra 2x6s in the picture, those are the first set I bought that I decided were not straight enough.
![cimg4078.jpg](/community/proxy.php?image=http%3A%2F%2Fimg26.imageshack.us%2Fimg26%2F2421%2Fcimg4078.jpg&hash=803586a3ef1c34ca4f8a059c840a02c8)
Since my garage floor isn't even close to flat or level, I added adjuster screws to the bottom of the legs. Has anyone else done this? How did it work out for you?
![cimg4081n.jpg](/community/proxy.php?image=http%3A%2F%2Fimg710.imageshack.us%2Fimg710%2F8568%2Fcimg4081n.jpg&hash=bd75384c27924a01bb6fec51e60f16dc)
Just for fun: I have been playing around with panel layouts - a bit premature...
So far I like this one.
![rv6panelimagev00.jpg](/community/proxy.php?image=http%3A%2F%2Fimg197.imageshack.us%2Fimg197%2F8293%2Frv6panelimagev00.jpg&hash=a9bffd108d8a26d1908d9832110c4abf)