BillL
Well Known Member
I have the G3X and a back up battery. There are 4 small sensor wires that connect to power. Main Volts, 2-amperage block, and trickle power for the IBBS. I need a 1, or 2, amp fuse for each and assume it should be located near the origin of power to avoid runs of unfused wires. I have these inline ATC fuse blocks but they are not tidy and will just be zip tied in a bundle. In searching for alternatives this fuse block came up:
(link : http://www.bluesea.com/products/5037/ST_Blade_Fuse_Block_-_6_Independent_Circuits )
It has a complete cover not shown. So, what are others using for these fuses, and is there a better block alternative?
Location?
A. Close to the solenoids, hard to get to, but neat with short unfused run.
B. Through the firewall? Pass through needed but then the fuse block could be accessed w/o removal of cowling.
Comments invited. I would like to get this ordered and moving. Thanks for your thoughts.
(link : http://www.bluesea.com/products/5037/ST_Blade_Fuse_Block_-_6_Independent_Circuits )
![5037.jpg](/community/proxy.php?image=https%3A%2F%2Flh3.googleusercontent.com%2F-An5pCAE7bQY%2FU0ak2wsBOFI%2FAAAAAAAAAXo%2FEPq1erKHBD4%2Fs800%2F5037.jpg&hash=58176ed21cfdb47d01a48d310868260a)
It has a complete cover not shown. So, what are others using for these fuses, and is there a better block alternative?
Location?
A. Close to the solenoids, hard to get to, but neat with short unfused run.
B. Through the firewall? Pass through needed but then the fuse block could be accessed w/o removal of cowling.
Comments invited. I would like to get this ordered and moving. Thanks for your thoughts.