skatetrainer
Member
Wings are getting near completion. I've built everything in the basement so far. Is it possible to construct the fuselage in two sections in order to remove the sections through a 36 inch door opening? Is there any other way to section the assemblies for removal?
Update, I have a 48 inch knee wall in the basement, a 42"x42" RO in a window with a 60 inch header, I built the 14'x32' addition so I could open up one of the walls or take out the window. The siding would have to be redone all the way up the wall. There is a 42 inch hallway leading to a 39 inch stair well split entry to a 36 inch door in a 6 foot door frame. Bottom line is that I was hoping to leave clecos in a seam in one direction. The main spar would prevent that though.
Update: I looked at the basement removal pics. Wish mine was that easy. Removing the knee wall would be the way to go.
Update, I have a 48 inch knee wall in the basement, a 42"x42" RO in a window with a 60 inch header, I built the 14'x32' addition so I could open up one of the walls or take out the window. The siding would have to be redone all the way up the wall. There is a 42 inch hallway leading to a 39 inch stair well split entry to a 36 inch door in a 6 foot door frame. Bottom line is that I was hoping to leave clecos in a seam in one direction. The main spar would prevent that though.
Update: I looked at the basement removal pics. Wish mine was that easy. Removing the knee wall would be the way to go.
Last edited: