dnimigon
Active Member
Back on the build again after a long break. I'm building the tanks and have most of the one done . Getting to the point of closing. Have a few issues with vent line. It doesn't say about drilling the hole for the vent line in the end rib. I looked around and all the ribs thinking I put one in wrong thinking one had a hole for this vent line but I didn't. Is this hole drilled near the top of the rib with no specific area as long as it's close to where the drawings show it. Also where does a person eventually vent this line once in the fuse. I kind of wonder why the vent line goes across the top of the tank and then drops down a bit before exiting the rib. Doesn't this create an area for fuel to get into which it will with fuel sloshing and plug the vent or will this line be vented downhill from their out the bottom of the fuse someplace.