[claycookiemonster]

SO...if I do the baffle before I do the inspection plate, I can make sure the fuel pick-up isn't clogged with sealant and see a bit of the baffle seal from the inside, BUT then how do I seal the plate screws on the inside?
OR...I could do the plate before I do the baffle and just hope the pick-ups are clear?
Comments?
Clay Cookie Monster
tanks, TANKS ALOT!!!!!
N838CM reserved

 

[DGlaeser]

Baffle first . . .

The inspection plate should go on last - after all that is it's purpose If you smear a bit of FuelLube on the screws they will seal just fine.