bhassel
Well Known Member
Chapter 28 -06 step 2 and on....
I was surprised when I started bending the return line that when you bend it the radius of the bend is smaller than the plans show. Is that normal? It almost looks like the radius in the plans for the 1/4" line is the same radius as the 3/8" line.
Did I goof somewhere?
Bob
I was surprised when I started bending the return line that when you bend it the radius of the bend is smaller than the plans show. Is that normal? It almost looks like the radius in the plans for the 1/4" line is the same radius as the 3/8" line.
Did I goof somewhere?
Bob