A question about how tight fuel fittings must be. I have an FI system and while installing the boost pump assembly, I found I needed to back off the T fitting between the fuel selector valve and the pump assembly to attain alignment. I needed to loosen the fitting 1/4 turn from tight for allignment.
Now I'm concerned that this might leak. I used EZ Turn on the fitting.
Any other experience the need to loosen for allignment?
Might this leak or will it be tight enough with the Tite Seal?
Jekyll
Now I'm concerned that this might leak. I used EZ Turn on the fitting.
Any other experience the need to loosen for allignment?
Might this leak or will it be tight enough with the Tite Seal?
Jekyll