skyyking56
Well Known Member
I see that on the forward end of the R915A (longest rudder stiffener bottom) has a notch that when you cut from it (from stiffener detail on drawing) it gives the end about a 30 degree cut on the non hole leg of the angle. It doesnt say in the plans to cut every one like that because there are no guide notches on the shorter ones.
Do we assume that they are all typical to that angle or are just the bottom stiffeners angled. Do the rest just get cut perpendicular to both legs of the angle? (hope this makes sense)
Appreciate any advice!!!!!!!!
Jim
7A Rudder
Do we assume that they are all typical to that angle or are just the bottom stiffeners angled. Do the rest just get cut perpendicular to both legs of the angle? (hope this makes sense)
Appreciate any advice!!!!!!!!
Jim
7A Rudder