Raving Nomad
Member
Hello folks,
I think I made a little mistake. The plans say that I have to bevel the wing skins where the inboard and outboard skins meet . I forgot to do that and went ahead and dimpled the skins - all 4 - top and bottom. So in its current state, I can't really get a nice bevel as intended.
One option I thought of was to try and bevel the outer surface (the female side of the dimple) so I'd kinda get the same result. Couldn't think of any other options.
a. Is that an acceptable approach?
b. Any other ideas?
Thanks in advance!
I think I made a little mistake. The plans say that I have to bevel the wing skins where the inboard and outboard skins meet . I forgot to do that and went ahead and dimpled the skins - all 4 - top and bottom. So in its current state, I can't really get a nice bevel as intended.
One option I thought of was to try and bevel the outer surface (the female side of the dimple) so I'd kinda get the same result. Couldn't think of any other options.
a. Is that an acceptable approach?
b. Any other ideas?
Thanks in advance!