cjensen
Well Known Member
Could someone make a quick measurement for me on your flap weldment where the unpowdercoated ring is located on the main bar?
I have mine striped down again, and I need to tell the powdercoater where to mask off the bar for the support block.
I need a measurement from whichever side it is on, and the width of the section that is left bare.
Thanks!!
__________________
I have mine striped down again, and I need to tell the powdercoater where to mask off the bar for the support block.
I need a measurement from whichever side it is on, and the width of the section that is left bare.
Thanks!!
__________________